Description
Hex receiver support
6061 aluminum construction
Special hard coating that reduces chipping and scratching
Resistance to salt spray corrosion
3 mounting points (two on the top forward part of the receiver and one on the left side of the receiver in the stripper clip guide area). Our scope mounts use the same top two mounting points as some similar mounts on the market.
No stock inletting needed (unless you are using a Boyd’s replacement stock). You may need to do some light sanding around the receiver area
Design that allows the shooter to get a lower, more proper check weld
Places scope closer for better eye relief
Supports the rear of the scope to eliminate movement for improved accuracy, unlike other mounts on the market
Secondary Picatinny rail mounted at a 90 degree angle
This scope mount includes:
3 mounting screws
Allen wrench
Detailed installation instructions
